DEV Community

朱连兴
朱连兴

Posted on

Router placement, wall materials, and the two range numbers we publish

We publish exactly two range numbers for the sensing unit: about 10 metres in the same room, and about 5 metres through one ordinary interior wall. Both are deliberately modest, and both come with a caveat that matters more than the numbers themselves: outside that envelope the product does not guess, it shows "no signal".

Here are the deployment notes behind those numbers, because a range figure without its conditions is marketing, not engineering.

What "ordinary interior wall" means

A plasterboard or light brick partition behaves nothing like a reinforced concrete shear wall, a wall with metal mesh, a tiled bathroom wall, or a large aquarium. We tested in a normal apartment, not an anechoic chamber. At 2.4 GHz, a running microwave, a dense cluster of neighbours' access points, and a metal cabinet between the unit and the router all move the received signal strength enough to change the state estimate. So we say "one ordinary interior wall" and we mean it literally. If your layout has two walls, or one concrete one, plan for a blind spot rather than assuming the number scales linearly.

Placement beats transmit power

The intuitive move is to put the unit next to the router. In practice the useful signal is the disturbance a person causes to the field inside the room being observed, so the unit belongs in that room, with a reasonably stable link back to the router. Putting it in the hallway gives you a great link and a poor measurement. We would rather ship a device that says "no signal" when it is badly placed than one that quietly reports a confident-looking wrong state.

One box, one room

We do not claim whole-flat coverage. The honest answer for a second room is another unit, or an explicitly acknowledged blind spot. A coverage map drawn from a single test flat would be the easiest slide in the deck to make and the least useful one in the field.

Failures are part of the interface

Power cut, router reboot, and a dropped link all render the same way: a separate state that says the signal is gone. We do not backfill a pleasant-looking history after the link returns, and we do not leave the last good reading on screen pretending to be current. A stale "all fine" is the most dangerous thing a care display can show. The unit samples roughly once per second, but the board presents the state of an interval, not a live feed.

The boundary, stated up front

This is a small presence display. It is not a medical device, it does not diagnose anything, and it does not provide an emergency response. In an emergency, call 120. It does not send alerts, does not measure heart rate or breathing, and does not claim to detect falls. It answers one narrow question: has this room changed recently. Everything we could not support, we wrote into the boundary document before we wrote the product page.

The unit is 499 CNY including the first month of service, then 30 CNY per month. The live board is public at annest.cn/live/ and reports from a real occupied flat, not a recorded loop.

Top comments (0)